Knowledgebase
Knowledgebase: Syngene
TGenius Back Focus Adjustment
Posted by Stephen Barnard on 06 October 2015 03:26 PM

T-Genius Lens Back Focus

 

Set Aperture to fully open.

Zoom in fully, focus with the software controls.

Zoom out fully.

If the image goes out of focus then the back focus is wrong.

The TGENIUS back focus controls are on the side of the lens.

 Lens

Loosen the lock screw slightly with a 1.5mm hex driver. Then adjust the back focus with the flat head screwdriver until the image is in focus.

When the focus is correct tighten the locking screw again.

 

Zoom in, adjust focus in software, zoom out. Image should stay in focus. If not the repeat the above.

(0 vote(s))
Helpful
Not helpful

Comments (0)